Timber roof trusses and fire regulations

2017-07-05 06:01
A timber roof.PHOTO: sourced

A timber roof.PHOTO: sourced

Multimedia   ·   User Galleries   ·   News in Pictures Send us your pictures  ·  Send us your stories

WHILE there are a few misconceptions around timbers fire performance, structural timber for roofing is both commonplace and performs well under fire conditions. As with every aspect of building, timber roof trusses must be manufactured and erected in line with the National Building Regulations and SANS 10400, which provide for fire safety.

Building regulations, set in place by the South African Bureau of Standards (SABS) after extensive research and consultation with industry experts, consider all aspects of a given building material’s composition and properties to ensure that it meets the same safety and performance standard as any other building material in the same application.

Fire regulations relating to timber roof trusses state the following:

• Each independent dwelling unit situated on either side of a fire wall must have its own bracing system within its roof structure, regardless of the fire wall projecting above the roof covering or not.

• The fire regulations do not state the size of a permissible gap between timber members bearing on either side of the fire wall. However, trusses passing through a fire wall must be split into separate trusses.

• The regulation states that “No part of the roof assembly, made of wood or any other combustible material shall pass through the separating wall.”

• No tile underlay or insulation may pass over the fire wall.

The Department of Public Works’ revised Guide to Architects on the subject of fire safety (1998: pp. 3), addresses the matter of fire walls in roof spaces as follows:

“Fire walls, where required, shall be carried up tightly against the underside of the floor except that combustible minor structural members, such as battens, to which roofing material is directly fastened, may be permitted. Purlins must not penetrate a fire wall for a distance greater than 80 mm, but if they penetrate from both sides of the wall, at least 80 mm of non-combustible material must separate them.”

While the Institute for Timber Construction South Africa (ITC-SA) does not make the regulations governing timber construction in South Africa, as part of its endeavours to promote and protect the industry, its players and the general public, it interprets and disseminates them. It is the responsibility of all players, from the manufacture to erection and inspection of timber roof trusses to enforce the regulations; even engineers who sign off on a non-compliant roof structure could well be put to task by the Engineering Council of South Africa.

Professor Walter Burdzik of the Department of Civil Engineering at the University of Pretoria confirms. “Any failure of a truss plant or roof inspector to insist on the separation of roofs per fire regulations needs to be reported to the ITC-SA. The same principle applies to low-cost housing, just because a roof is over a low-cost house does not justify deviating from National Building Regulations.”

The Institute thus urges all responsible along the timber roof truss value chain to play their part and act in accordance with the National Building Regulations SANS 10400 and Building Standards Act 103 of 1977.

Join the conversation!

24.com encourages commentary submitted via MyNews24. Contributions of 200 words or more will be considered for publication.

We reserve editorial discretion to decide what will be published.
Read our comments policy for guidelines on contributions.

Inside News24

Traffic Alerts
There are new stories on the homepage. Click here to see them.


Create Profile

Creating your profile will enable you to submit photos and stories to get published on News24.

Please provide a username for your profile page:

This username must be unique, cannot be edited and will be used in the URL to your profile page across the entire 24.com network.


Location Settings

News24 allows you to edit the display of certain components based on a location. If you wish to personalise the page based on your preferences, please select a location for each component and click "Submit" in order for the changes to take affect.

Facebook Sign-In

Hi News addict,

Join the News24 Community to be involved in breaking the news.

Log in with Facebook to comment and personalise news, weather and listings.